Garbage Disposal Repair
Jammed, humming, leaking or dead disposals, cleared, repaired or replaced and reconnected properly.
DetailsA dishwasher with water sitting in the bottom, a puddle on the floor or a gritty film on every glass is telling you which part to look at. We follow the water from the inlet valve to the drain.
Updated October 2026

Dishwasher repair in Jacksonville usually involves a clogged filter or failed drain pump, a leaking door gasket or pump seal, a scaled spray arm, a failed inlet valve or a heating element. We trace the water path, fix the failed part and run a full cycle to confirm no leaks before leaving.
A dishwasher fills through an inlet valve, circulates water through the spray arms with a wash pump, drains it with a drain pump and dries with a heater or condensation. Where the water ends up wrong tells us which part failed: standing water means the drain side, low or no water means the inlet side, and a puddle under the door means a seal, the gasket or overfilling.
Many dishwasher calls start with the filter. Most newer dishwashers have a manual filter in the bottom of the tub that must be cleaned by hand. When it clogs, the dishwasher drains slowly, washes poorly and smells. We clean it and show you how, before replacing any pump.
Warning signs
Drain side problem.
Gasket, level or suds problem.
Filter, spray arms or wash pump.
Something jammed in a pump.
Water on the kitchen floor? Turn the dishwasher off and call us now.
Call (904) 907-8788The jobs this page covers
Standing water after a cycle usually comes from a clogged filter, a kinked drain hose, a disposal with a clog or its knockout plug never removed on a new install, or a drain pump that is jammed or failed. We work from the cheapest cause to the most expensive one: filter, hose loop and air gap, disposal connection, then the pump itself. A pump jammed with a piece of glass or a fruit pit can often be cleared without replacing it. If the pump motor has failed, it is a straightforward replacement on most models.
A leak at the front bottom of the door usually comes from a worn door gasket, a cracked tub, the wrong detergent making suds, or the dishwasher not sitting level. A leak underneath can be the pump seal, a loose hose clamp, the inlet valve or a cracked spray arm hub. We pull the toe kick, run the dishwasher and watch for the source with a light. Bosch E15 and similar leak codes mean water has already reached the base pan, and we find the leak before resetting the float.

Gritty film, food left on the top rack or spots on glasses point at the spray arms, the filter, the wash pump or the water temperature. Spray arm holes clog with scale and food bits, and in a hard-water area the arms can be half blocked. We clean the arms and filter, check that the wash pump moves enough water, confirm the water reaching the dishwasher is hot enough and check the detergent dispenser opens on time. Most of the time those steps fix it without a major part.
Dishwashers dry either with a heating element and a vent, or by condensation on a cool stainless tub with rinse aid. If yours has an element, we test it, the high-limit thermostat and the vent fan. If it relies on condensation, empty rinse aid or a dispenser that does not release it is the most common cause of wet dishes. Plastics never dry as well as glass in condensation models, and we will tell you when wet plastics are normal rather than a failed part.
Jacksonville tap water is drawn from the Floridan aquifer through limestone, so most homes here have moderate to hard water. In a dishwasher that shows up as white film on glasses, scale in the spray arm holes and a filter that clogs faster than the manual suggests. After a repair we set the dishwasher's water hardness setting, if it has one, and talk you through rinse aid and a monthly cleaning cycle.
Step by step
The quickest causes come first.
Inlet, wash, drain and seals tested in a run.
Part replaced, hoses and clamps checked.
We watch underneath for leaks.
DIY or call
| Task | Safe to try yourself | Call a technician |
|---|---|---|
| Water in the bottom | Clean the manual filter | If water still stands |
| White film | Add rinse aid, run a cleaning cycle | If spray arms are blocked or film persists |
| New dishwasher will not drain | Check the disposal knockout plug was removed | If it was removed |
| Leak at the door | Use only dishwasher detergent | If it still leaks |
Cost
Dishwasher repairs range from a filter cleaning or inlet valve to a pump or control board. The range here is national cost data for dishwasher repairs.
Planning range from published cost data (homeadvisor.com), not a quote and not our price. Your number depends on the diagnosis and the part.
Dishwashers we repair: Bosch, Whirlpool, KitchenAid, GE, Samsung, LG, Frigidaire and Miele.
FAQ
A clogged filter, a kinked drain hose, a clogged disposal or a failed drain pump. Clean the filter first; if water remains, call.
Hard water minerals. Use rinse aid, set the hardness setting if available and run a cleaning cycle. A water softener helps the whole house.
For pumps, valves, gaskets and heaters, usually yes. If the tub is cracked or the board fails on an older unit, replacement may be better.
Food trapped in the filter and the drain hose loop. Clean the filter weekly and run a hot cleaning cycle.
Water has reached the base pan and tripped the leak float. The leak needs to be found before the dishwasher will run normally.
Also on the list
Jammed, humming, leaking or dead disposals, cleared, repaired or replaced and reconnected properly.
DetailsElectric and gas tank water heaters with no hot water, short hot water or leaks, repaired at the element, valve or anode.
DetailsSofteners that stopped regenerating, bridged salt, low flow or hard water returning, serviced and reset.
DetailsTurn it off at the circuit if water is on the floor, then call. A person answers any hour.
Duval Appliance serves Jacksonville and the First Coast from 6504 Leona Street in northwest Jacksonville.