Washing Machine Repair
Washers that will not drain, spin, fill or stay quiet, front-load and top-load, repaired in your laundry room.
DetailsStacked laundry saves floor space and makes repairs harder. The machines sit in tight closets, the dryer is on top and the washer cannot slide out until the pair is separated, so planning matters as much as parts.
Updated October 2026

Stackable washer dryer repair in Jacksonville covers one-piece laundry centers, stacked front-load pairs and all-in-one combo units. The common failures match regular washers and dryers, but access takes planning, so we confirm the model and closet space before the visit and protect walls and floors while we work.
A laundry center is one cabinet with a small top-load washer below and a dryer above, sold by Frigidaire, GE and Whirlpool among others. A stacked pair is two full-size front-loaders joined with a stacking kit. An all-in-one combo washes and dries in one drum, often without a vent. Each opens differently and fails in slightly different places.
Most of the repairs are the same as standalone machines: drain pumps, door locks, belts, heating elements. The difference is getting to them. We ask for the model and a photo of the closet when you call, so we arrive with the right parts and a plan for access.
Cost
We price stackable repairs after diagnosis. The parts cost about the same as on standalone machines; what changes is the labor to reach them, which we tell you before work starts.
No flat price over the phone. We price after the diagnosis, part and labor separately, so you can decide before any work starts.
The jobs this page covers
In a one-piece laundry center the washer below is a compact top-load machine and the dryer above shares the same frame and often the same control panel. Common repairs are the washer's drain pump, lid switch and drive belt, and the dryer's belt, heating element and thermal fuse. Many repairs are done from the front with the lower panel off, but some require sliding the whole unit forward, so we bring floor protection and check the water and drain connections behind it while it is out.

Combo units wash and dry in a single drum and many dry by condensing moisture with cool water instead of venting outside. That makes them popular in condos and apartments without a dryer vent. Long dry times on a combo usually mean a clogged condenser path or lint trap, a failing heater or a fan problem. Because they run longer cycles than separate machines, we time the drying phase against the model's specification before deciding whether something has truly failed.
Many stacked pairs live in hallway closets with the doors removed and only a few inches to spare on each side. For washer repairs that cannot be reached from the front, the dryer has to come down first. We do that with two technicians and a lift strap, protect the walls and floor, and check the stacking kit and the dryer vent connection before putting it back. A crushed vent hose behind a stacked dryer is one of the most common things we find.
What is included
Arlington grew fast after the Mathews Bridge opened in 1953, and many of the houses from that era, including planned subdivisions like Sandalwood, were built with small laundry closets that now hold stacked machines. Those closets leave little room to work and often hide long, tired vent runs. We plan the access before we arrive and look at the vent while the dryer is out.
Step by step
Model and closet photo reviewed before the visit.
Floor and wall protection, unstacking only if needed.
The failed part replaced on the machine that needs it.
Stacking kit, vent and hoses checked, then a full cycle.
Timing
A front-access repair on a laundry center takes about as long as a standalone washer or dryer, usually an hour or two. When a stacked pair has to be separated, plan on extra time and two technicians, and we schedule it that way from the start so nobody is surprised.
Stacked units we see: GE, Frigidaire, Whirlpool, Maytag, LG and Samsung laundry centers and pairs.
FAQ
Often, if the repair is reachable from the front. Pump, filter and door boot work usually is. Some bearing and drive repairs need the pair separated.
Combos dry slowly by design, but very long cycles usually point at a clogged condenser path, lint trap, heater or fan.
Usually yes for belts, pumps, switches and elements. If the shared control fails on an older unit, replacement may make more sense.
Yes. See our washer and dryer installation page for stacking and hookups.
We protect the floor and the walls and use lift straps when the dryer has to come down.
Also on the list
Washers that will not drain, spin, fill or stay quiet, front-load and top-load, repaired in your laundry room.
DetailsElectric dryers that run cold, will not tumble, squeal or take two cycles, repaired at home.
DetailsGas dryers that click without lighting or light and go out, igniters, coils and flame sensors repaired.
DetailsFull-length dryer vent cleaning from the dryer to the outside hood, including roof vents and crushed hoses.
DetailsSend us the model when you call and tell us which machine failed. We plan the access before we arrive.
Duval Appliance serves Jacksonville and the First Coast from 6504 Leona Street in northwest Jacksonville.